[epgun]

does anyone know the spec for this turbo

Turbonetics BIG frame 60-1 Q trim .63ar

[Robert]

Originally Posted by epgun

does anyone know the spec for this turbo

Turbonetics BIG frame 60-1 Q trim .63ar

What do you mean by the spec?

[epgun]

what its maximum output based on k20a2

also i get oil runing out of the compressor side when i am parked small drops . also during high boost over 1 bar just smokes out of tha back . new stem oil seals and piston rings been fitted too and still same no kinks on the return

[Robert]

Originally Posted by epgun

what its maximum output based on k20a2

also i get oil runing out of the compressor side when i am parked small drops . also during high boost over 1 bar just smokes out of tha back . new stem oil seals and piston rings been fitted too and still same no kinks on the return

Are you running a catch can? If not what is your typical oil pressure under load? In regards to maximum output the 60-1 compressor section has a max flow rate of 57 lb/min within its efficiency island. Depending on your motor's VE and several other factors you can look for somewhere in the neighborhood of 550-570 CHP but this will be largely based on the rest of your set up.

[epgun]

thanks rob my oil press is 6 bar . also i have noticed if i go over 1 bar boost i just generate a smoke cloud

[epgun]

bump